Toyota Venza: Installation

Toyota Venza Service Manual / Audio / Video / Satellite Radio Tuner / Installation

INSTALLATION

PROCEDURE

1. INSTALL STEREO COMPONENT TUNER ASSEMBLY

2. INSTALL NAVIGATION WIRE

(a) Connect the 3 connectors to install the navigation wire.

3. INSTALL STEREO COMPONENT TUNER ASSEMBLY WITH WIRE

(a) Install the stereo component tuner assembly with wire with the 4 screws.

(b) Connect the 3 connectors.

4. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY (w/o Navigation System)

5. INSTALL INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY (w/ Navigation System)

6. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)

7. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)

8. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

9. INSTALL CONSOLE BOX SUB-ASSEMBLY

10. INSTALL POSITION INDICATOR HOUSING ASSEMBLY

11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

12. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY

13. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

14. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

15. INSTALL FRONT DOOR SCUFF PLATE RH

16. INSTALL AIR CONDITIONING CONTROL ASSEMBLY

17. INSTALL CONSOLE BOX ASSEMBLY

18. INSTALL NO. 2 CONSOLE BOX CARPET

19. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)

20. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)

21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Navigation System)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

Removal

REMOVAL PROCEDURE 1. PRECAUTION (w/ Navigation System) NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery te ...

Stereo Component Amplifier

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY RH (for Manual Seat) HINT: Use the same procedure for the RH side and the LH side (See page ) ...

Other materials about Toyota Venza:

Starter Relay Circuit High (P0617)
MONITOR DESCRIPTION While the engine is being cranked, battery voltage is applied to terminal STA of the ECM. If the ECM detects the Starter Control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circu ...

Occupant Classification Ecu
Components COMPONENTS ILLUSTRATION ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the occupant classification ECU. PROCEDURE 1. ...

SRS Warning Light does not Come ON
DESCRIPTION The SRS warning light is located on the combination meter assembly. When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the ignition switch is turned from off to ON, and then goes off automatically. If ther ...