Toyota Venza manuals

Toyota Venza: Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR SEAT INNER BELT ASSEMBLY RH

(a) Install the rear seat inner belt assembly RH with the bolt.

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}


2. INSTALL REAR SEAT CUSHION COVER WITH PAD


3. INSTALL REAR SEAT CENTER ARMREST ASSEMBLY


4. INSTALL REAR SEAT RECLINING COVER RH


5. INSTALL CENTER SEAT HINGE COVER RH


6. INSTALL REAR SEAT INNER RECLINING COVER RH


7. INSTALL REAR SEAT RECLINING RELEASE LEVER RH


8. INSTALL SEAT ADJUSTER COVER CAP RH


9. INSTALL REAR SEAT ASSEMBLY RH


10. CONNECT REAR SEAT RECLINING CONTROL CABLE SUB-ASSEMBLY


11. INSTALL REAR SEAT OUTER TRACK BRACKET COVER


12. INSTALL REAR SEAT INNER TRACK BRACKET COVER


13. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY


14. INSTALL REAR SEAT HEADREST ASSEMBLY


Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT HEADREST ASSEMBLY 2. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY 3. REMOVE REAR SEAT INNER TRACK BRACKET COVER 4. REMOVE REAR SEAT OUTER TRACK BRACKET ...

Rear Seat Outer Belt Assembly
...

Other materials about Toyota Venza:

Rear Airbag Sensor LH Circuit Malfunction (B1635/24)
DESCRIPTION The side collision sensor LH circuit (to determine deployment of the front seat side airbag assembly LH and curtain shield airbag assembly LH) is composed of the center airbag sensor assembly, rear airbag sensor LH and side airbag sensor LH. ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR BUMPER PLATE LH (a) Using a screwdriver with the tip wrapped with protective tape, disengage the 2 claws and remove the rear bumper plate LH. Text in Illustration *1 Pro ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Starting Control or Power Source Control / Trouble Codes. (e) Read t ...

© 2016-2025 Copyright www.tovenza.com

0.1763