Toyota Venza manuals

Toyota Venza: Installation

INSTALLATION

PROCEDURE

1. INSTALL STARTER ASSEMBLY

(a) Install the starter with the 2 bolts.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}


(b) Connect the starter connector.


(c) Install the terminal nut and cover the nut with the cap.

Torque:

9.8 N·m {100 kgf·cm, 87 in·lbf}

2. INSTALL BATTERY


3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


4. INSTALL COOL AIR INTAKE DUCT SEAL


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT: Use high-temperature grease to lubricate the bearings, gears and return spring when assembling the starter. PROCEDURE 1. INSTALL PLANETARY GEAR ...

Starting System
Parts Location PARTS LOCATION ILLUSTRATION ILLUSTRATION System Diagram SYSTEM DIAGRAM ...

Other materials about Toyota Venza:

Speedometer Malfunction
DESCRIPTION The meter CPU receives vehicle speed signals from the skid control ECU via the CAN communication system (CAN No. 1 Bus). The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. The skid control ECU ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE RADIATOR ASSEMBLY HINT: See page 3. REMOVE V-RIBBE ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (a) Disconnect the D47 air conditioning amplifier assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wi ...

© 2016-2026 Copyright www.tovenza.com

0.1737