Toyota Venza manuals

Toyota Venza: Inspection

INSPECTION

PROCEDURE

1. INSPECT NO. 1 ULTRASONIC SENSOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 (BI) - 5 (EI)

Always

10 kΩ or higher

1 (BI) - 2 (BO)

Always

10 kΩ or higher

3 (SI) - 4 (SO)

Always

Below 1 Ω

5 (EI) - 6 (EO)

Always

Below 1 Ω

Text in Illustration

*a

Component without harness connected

(No. 1 Ultrasonic Sensor)

If the result is not as specified, replace the No. 1 ultrasonic sensor.


Components
COMPONENTS ILLUSTRATION ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR BUMPER ASSEMBLY (See page ) 2. REMOVE ULTRASONIC SENSOR CLIP (a) Disconnect the connector. Text in Illustration *A ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT HEADREST ASSEMBLY 2. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY 3. REMOVE REAR SEAT INNER TRACK BRACKET COVER 4. REMOVE REAR SEAT OUTER TRACK BRACKET COVER 5. DISCONNECT REAR SEAT RECLINING CONTROL CABLE S ...

Communication Malfunction No. 1 (B2797)
DESCRIPTION This DTC is stored when an error occurs in communication between the transponder key amplifier and the transponder key ECU assembly. HINT: Some noise is found in the communication line. DTC No. DTC Detection Condition ...

Assist Map Number Mismatch (C1582)
DESCRIPTION When an incorrect ECM or brake actuator assembly (skid control ECU) is installed after the assist map has been recorded in the power steering ECU, then DTC C1582 is stored because the data does not match the vehicle specifications. ...

© 2016-2026 Copyright www.tovenza.com

0.1256