Toyota Venza manuals

Toyota Venza: Inspection

INSPECTION

PROCEDURE

1. INSPECT COURTESY LIGHT SWITCH

(a) Measure the resistance according to the value(s) in the table below.


Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

1 - Switch body

Pushed

10 kΩ or higher

1 - Switch body

Not pushed

Below 1 Ω

Text in Illustration

*1

Component without harness connected

(Courtesy Light Switch)

*2

Switch Body

If the result is not as specified, replace the courtesy light switch.

Removal
REMOVAL PROCEDURE 1. REMOVE REAR DOOR SCUFF PLATE 2. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 3. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 4. REMOVE DECK BOARD ASSEMBLY ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DOOR COURTESY LIGHT SWITCH (a) Using "TORX" socket wrench T30, install the rear door courtesy light switch with the "TORX" ...

Other materials about Toyota Venza:

Stop Light Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the connector. (b) Turn the stop light switch assembly countercl ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Sliding Roof) 2. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof) 3. REMOVE VANITY LIGHT ASSEMBLY (a) Remove the vanity light assembly (See page ). HINT: Use the same p ...

Window Defogger Wire
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. CHECK REAR WINDOW DEFOGGER SYSTEM OPERATION (a) When the ignition switch is turned to ON and the rear window defogger switch is pressed, check that the rear window defogger system operates. 2. I ...

© 2016-2026 Copyright www.tovenza.com

0.1127