Toyota Venza: HD Radio Tuner Malfunction (B1551,B158D,B15A0,B15B0,B15B3,B15B4,B15B7)

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / HD Radio Tuner Malfunction (B1551,B158D,B15A0,B15B0,B15B3,B15B4,B15B7)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.

DTC No.	DTC Detection Condition	Trouble Area
B1551	When any of the following conditions is met: "HD Radio" tuner decorder malfunction "HD Radio" tuner audio output section malfunction "HD Radio" tuner decorder RF/IF malfunction	Radio and display receiver assembly
B158D	The internal video signal of the radio and display receiver assembly is interrupted
B15A0	When either of the following conditions is met: Bus malfunction EEPROM error
B15B0	Picture circuit (TFT unit) malfunction
B15B3	When any of the following conditions is met: AM tuner PLL is unlocked FM tuner PLL is unlocked Tuner malfunction
B15B4	When any of the following conditions is met: Mechanism drive signal malfunction Load/Eject malfunction Read mechanism malfunction Mechanical malfunction
B15B7	"Bluetooth" module malfunction

PROCEDURE

CHECK DTC

(a) Clear the DTCs (See page ).

(b) Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.

USE SIMULATION METHOD TO CHECK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

LVDS Signal Malfunction (from Extension Module) (B1532)

DESCRIPTION The stereo component tuner assembly and the radio and display receiver assembly are connected by an LVDS communication line. This DTC is stored when an LVDS communication error occurs ...

Satellite Radio Broadcast cannot be Received

CAUTION / NOTICE / HINT NOTICE: Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be p ...

Other materials about Toyota Venza:

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2. CUSTOMER PROBLEM ANALYSIS ...

Battery
- Battery exterior Make sure that the battery terminals are not corroded and that there are no loose connections, cracks, or loose clamps. 1. Terminals 2. Hold-down clamp - Before recharging When recharging, the battery produces hydrogen g ...

SRS Warning Light Remains ON
DESCRIPTION The SRS warning light is located on the combination meter assembly. When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the ignition switch is turned from off to ON, and then goes off automatically. If ther ...