Toyota Venza manuals

Toyota Venza: For owners

Reporting safety defects for U.S. owners, and seat belt and SRS airbag instructions for Canadian owners

Items to initialize
The following items must be initialized for normal system operation in cases such as after the battery is reconnected, or maintenance is performed on the vehicle. ...

Reporting safety defects for U.S. owners
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE REAR WHEELS 2. REMOVE CENTER EXHAUST PIPE ASSEMBLY (a) Remove the center exhaust pipe assembly. HINT: Refer to the instructions for Removal of the exhaust pipe (See page for 2GR-FE, for 1AR-FE). 3. REMOVE LOWER NO. 1 EXH ...

Installation
INSTALLATION PROCEDURE 1. INSTALL GENERATOR ASSEMBLY (a) Install the wire harness clamp with the bolt. Torque: 8.4 N·m {86 kgf·cm, 74 in·lbf} (b) Install the 2 bolts. Torque: ...

Inspection
INSPECTION PROCEDURE 1. INSPECT ATF TEMPERATURE SENSOR ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Sp ...

© 2016-2026 Copyright www.tovenza.com

0.1603