Toyota Venza: Abbreviation list

Reporting safety defects for U.S. owners

If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in ...

Toyota Venza Service Manual

...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems ne ...

Relay
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT IG2 RELAY (a) Remove the IG2 relay from the relay block. (b) Measure the resistance according to the value(s) in the table below. Standard Resistance: Te ...

Removal
REMOVAL PROCEDURE 1. REMOVE YAW RATE AND ACCELERATION SENSOR HINT: Refer to the instructions for Removal of the yaw rate and acceleration sensor (See page ). 2. REMOVE REAR NO. 2 AIR DUCT 3. REMOVE REAR NO. 1 AIR DUCT 4. REMOVE FRONT NO. 2 FLOO ...