DIAGNOSTIC TROUBLE CODE CHART
If a trouble code is displayed during the DTC check, check the parts listed for that code in the table below and proceed to the appropriate page.
HINT:
The steering lock ECU does not store DTCs regarding the past problems.
Steering Lock System|
DTC Code |
Detection Item |
Trouble Area |
See page |
|---|---|---|---|
|
B2781 |
Open / Short in Steering Lock ECU |
Steering lock ECU (Steering lock actuator assembly) |
|
|
B2782 |
Power Source Control ECU Malfunction |
1. Wire harness 2. Steering lock ECU (Steering lock actuator assembly) 3. Power management control ECU |
|
|
B2788 |
IG2 Signal Malfunction |
1. IG2 relay 2. Wire harness 3. Power management control ECU 4. Steering lock ECU (Steering lock actuator assembly) |
|
IG2 Signal Malfunction (B2788)
Power Source Control ECU Malfunction (B2782)Relay
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT DOME CUT RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
...
System Diagram
SYSTEM DIAGRAM
Communication Table
Transmitting ECU
(Transmitter)
Receiving ECU
(Receiver)
Signal
Communication Method
Combination meter
Power management control ECU
...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symptoms are listed in order
of probability in the "Suspected Area" column of the tab ...