Toyota Venza manuals

Toyota Venza: Installation

INSTALLATION

PROCEDURE

1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

(a) Install the brake pedal support assembly to the instrument panel reinforcement with the bolt.

Torque:

19 N·m {195 kgf·cm, 14 ft·lbf}


(b) Connect the connector.


2. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

3. INSTALL STOP LIGHT SWITCH ASSEMBLY


4. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY (w/ HID Headlight System)


5. INSTALL BRAKE BOOSTER ASSEMBLY

HINT:

Refer to the instructions for Installation of the brake booster assembly (See page ).


Reassembly
REASSEMBLY PROCEDURE 1. INSTALL STOP LIGHT SWITCH CUSHION (a) Install the stop light switch cushion to the brake pedal support assembly. 2. INSTALL BRAKE PEDAL PAD (a) Install the brake pedal pad ...

Brake System
...

Other materials about Toyota Venza:

Front Stabilizer Bar(when Not Using The Engine Support Bridge For Awd)
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT FRONT STABILIZER LINK ASSEMBLY (a) Inspect the turning torque of the ball joint. (1) Secure the front stabilizer link assembly in a vise using aluminum ...

Combination Meter ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Combination Meter ECU Communication Stop Mode "Combination Meter" is not displayed on "CAN Bus Check" screen of t ...

If you have a flat tire
Remove the flat tire and replace it with the spare provided. - Before jacking up the vehicle • Stop the vehicle on a hard, flat surface. • Set the parking brake. • Shift the shift lever to “P”. • Stop the engine. • Turn on the emergency f ...

© 2016-2026 Copyright www.tovenza.com

0.1598