Toyota Venza: Ultrasonic Sensor(for Rear Side)

Ultrasonic Sensor(for Front Side)

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY (See page ) 2. REMOVE NO. 1 ULTRASONIC SENSOR (a) Disengage the 2 claws to remov ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Open in Driver Side Electrical Antenna Circuit (B27A1)
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and sends it to the electrical key oscillator built into the front door outside handle assembly (for driver side) at 0.25-second intervals. To detect a key near the driv ...

Key-off Operation Function Operates even if Operating Conditions are not Satisfied
DESCRIPTION When the front doors are closed, each power window regulator motor assembly can control its power window operation for approximately 45 seconds after the ignition switch is turned from ON to off by receiving operation permission ...

4WD Control ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area 4WD Control ECU Communication Stop Mode "Four Wheel Drive Control" is not displayed on the "CAN Bus Check" screen ...