Toyota Venza: Roof Headlining

Installation

INSTALLATION PROCEDURE 1. INSTALL INSTRUMENT PANEL STAY (a) Engage the 3 claws to install the 3 instrument panel stays. 2. INSTALL INSTRUM ...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Registration
REGISTRATION CAUTION / NOTICE / HINT HINT: Register a new recognition code when replacing the door control transmitter or the door control receiver. Add mode is used to retain the already registered codes while registering a new recognit ...

Ultrasonic Sensor(for Front Side)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY (See page ) 2. REMOVE NO. 1 ULTRASONIC SENSOR (a) Disengage the 2 claws to remove the No. 1 ultrasonic sensor. HINT: Use the same proc ...

Installation
INSTALLATION PROCEDURE 1. TEMPORARILY INSTALL REAR STABILIZER BAR BRACKET LH (for Front Side) (a) Temporarily install the rear stabilizer bar bracket LH (front side) with the bolt. HINT: Loosely tighten the bolt so that the bracket can ...