Toyota Venza: Rear Brake

Brake (rear)

...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Installation
INSTALLATION PROCEDURE 1. TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (a) Remove SST from the transfer. SST: 09325-20010 (b) Install the propeller with center bearing shaft ...

Inspection
INSPECTION PROCEDURE 1. INSPECT LUMBAR SUPPORT ADJUSTER ASSEMBLY (a) Check operation of the lumbar support adjuster. (1) Check if the lumbar support adjuster moves smoothly when the battery is connected to the lumbar support adjuster motor connector te ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. PRECAUTION HINT: See page 2. DRAIN AUTOMATIC TRANSAXLE FLUID HINT: for U ...