Toyota Venza manuals

Toyota Venza: Brake (rear)

Front Brake Flexible Hose
Components COMPONENTS ILLUSTRATION Installation INSTALLATION CAUTION / NOTICE / HINT NOTICE: Because the left and right hoses are not interchangeable, verify the part number w ...

Rear Brake
...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the steering pad. PROCEDURE 1. INSPECT STEERING PAD (Vehicle not Involved in Collision) (a) Perform a diagnostic system check (S ...

Installation
INSTALLATION PROCEDURE 1. INSTALL YAW RATE AND ACCELERATION SENSOR (a) Install the yaw rate and acceleration sensor to the bracket with the 2 nuts. Torque: 5.0 N·m {51 kgf·cm, 44 in·lbf} ...

Replacement
REPLACEMENT PROCEDURE 1. REPLACE RING PIN NOTICE: It is not necessary to remove the ring pin unless it is being replaced. (a) Remove the 12 ring pins. (b) Using a plastic-faced hammer, install 12 new ring pins. Standard Protrusion Height: ...

© 2016-2026 Copyright www.tovenza.com

0.1543