Toyota Venza: Garage Door Opener System

Garage Door Opener Switch

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE ROOF CONSOLE BOX ASSEMBLY (GARAGE DOOR OPENER SWITCH) (a) Using a moulding remover, disengage the 2 claws ...

Parts Location

PARTS LOCATION ILLUSTRATION ...

Other materials about Toyota Venza:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK POSITION CONTROL ECU AND SWITCH ASSEMBLY (a) Disconnect the T10 and T11 position control ECU and switch assembly connectors. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure t ...

Installation
INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL LEVEL (a) When replacing the cooler compressor assembly with a new one, gradually discharge the inert gas (helium) from the service valve, and drain the following amount of oil from the vent ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY (a) Install the rear center seat outer belt assembly with the bolt and nut. Torque: Bolt : 7.5 N·m {77 kgf·cm, 66 in·lbf} Nut : 42 N·m {428 kgf·cm, ...