Toyota Venza manuals

Toyota Venza: Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

HINT:

If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to "See page" in the DTC chart.

  • Inspect the fuses and relays before troubleshooting the areas shown in the table below.
Wireless Door Lock Control System

DTC Code

Detection Item

Trouble Area

See page

B1242

Wireless Door Lock Tuner Circuit Malfunction

1. Wire harness or connector

2. Door control receiver

3. Main body ECU (driver side junction block assembly)


Dtc Check / Clear
DTC CHECK / CLEAR 1. DTC CHECK/CLEAR (USING TECHSTREAM) (a) CHECK DTC (1) Connect the Techstream to the DLC3. (2) Turn the ignition switch on (IG). (3) Read the DTC by following the prompts on th ...

Wireless Door Lock Tuner Circuit Malfunction (B1242)
DESCRIPTION The door control receiver receives signals from the transmitter and sends these signals to the main body ECU (driver side junction block assembly). DTC No. DTC De ...

Other materials about Toyota Venza:

Speed Signal Malfunction (B15C2)
DESCRIPTION The navigation receiver assembly receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna assembly, and then adjusts the vehicle position. The navigation receiver assembly stores this DTC ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL BEARING BRACKET HOLE SNAP RING (for RH Side) (a) Install a new bearing bracket hole snap ring to the front drive shaft assembly RH. 2. INSTALL FRONT DRIVE SHAFT BEARING (for RH Side) (a) Using SST, install a ne ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART HINT: If a trouble code is displayed during the DTC check, inspect the trouble areas listed below for that code. For details of the code, refer to the following "See page". Power back door system DTC C ...

© 2016-2026 Copyright www.tovenza.com

0.1333