Toyota Venza: XM Tuner Malfunction (B15BA)

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / XM Tuner Malfunction (B15BA)

DESCRIPTION

This DTC is stored when a malfunction occurs in the stereo component tuner assembly.

DTC No.	DTC Detection Condition	Trouble Area
B15BA	When either of the following conditions is met: Internal IC malfunction Tuner malfunction	Stereo component tuner assembly

CAUTION / NOTICE / HINT

NOTICE:

After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

PROCEDURE

CHECK DTC

(a) Clear the DTCs (See page ).

(b) Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.

USE SIMULATION METHOD TO CHECK

REPLACE STEREO COMPONENT TUNER ASSEMBLY

Stereo Component Amplifier Malfunction (B15A3)

DESCRIPTION This DTC is stored when a malfunction occurs in the stereo component amplifier assembly. DTC No. DTC Detection Condition Trouble Area ...

Short in GPS Antenna (B15C0,B15C1)

DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. DTC Detection Condition Trouble Area B15C0 ...

Other materials about Toyota Venza:

Control Module Communication Bus OFF (U0073/86,U0100/85,U0129/83)
DESCRIPTION The AWD control ECU inputs the signals sent from the ECM and skid control ECU via the CAN communication system. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before r ...

Pressure Control Solenoid "C" Performance (Shift Solenoid Valve SL3) (P0796)
SYSTEM DESCRIPTION The TCM uses the vehicle speed signal and signals from the transmission speed sensors (NC, NT) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear). Then the TCM compares the actual gear with the shift schedule in the TCM memo ...

Pressure Control Solenoid "G" Performance (Shift Solenoid Valve SL4) (P2808)
DESCRIPTION The TCM uses the vehicle speed signal and signals from the transmission speed sensors (NC, NT) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear). Then the TCM compares the actual gear with the shift schedule in the TCM memory to ...