Toyota Venza: XM Tuner Malfunction (B15BA)

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / XM Tuner Malfunction (B15BA)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the stereo component tuner assembly.

DTC No.	DTC Detection Condition	Trouble Area
B15BA	When either of the following conditions is met: Internal IC malfunction Tuner malfunction	Stereo component tuner assembly

CAUTION / NOTICE / HINT

NOTICE:

After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

PROCEDURE

CHECK DTC

(a) Clear the DTCs (See page ).

(b) Recheck for DTCs and check that no DTCs are output.

OK:

No DTCs are output.

USE SIMULATION METHOD TO CHECK

REPLACE STEREO COMPONENT TUNER ASSEMBLY

Short in GPS Antenna (B15C0,B15C1)

DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. DTC Detection Condition Trouble Area B15C0 ...

AV Signal Stoppage (Low Battery Voltage) (B158F)

DESCRIPTION This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily. DTC No. ...

Other materials about Toyota Venza:

Combination Meter ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Combination Meter ECU Communication Stop Mode "Combination Meter" is not displayed on "CAN Bus Check" screen of t ...

Personal/interior lights
► Front On/off The illuminated entry system is activated even if the light is turned off when the personal/interior light main switch is in door position. ► Rear On/off The illuminated entry system is activated even if the light is turne ...

Yaw Rate Sensor Output Malfunction (C1448/98)
DESCRIPTION The skid control ECU receives signals from the yaw rate and acceleration sensor via the CAN communication system. The yaw rate sensor has a built-in acceleration sensor and detects the vehicle condition. DTC Code DTC De ...