Toyota Venza: Wiper And Washer System

Washer Nozzle(for Rear Side)

Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REAR WASHER NOZZLE (a) With the engine running, check where the washer fluid hits the w ...

Precaution

PRECAUTION NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Proc ...

Other materials about Toyota Venza:

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the ''See page'' below. Front Power Seat Control System (w/ Memory) ...

Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

Cellular Phone Registration Failure
PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updating software, etc. is necessary, make sure to obtain the per ...