Toyota Venza: How To Proceed With Troubleshooting

Toyota Venza Service Manual / Window / Glass / Windshield Deicer System / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use the following procedure to troubleshoot the windshield deicer system.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	CUSTOMER PROBLEM ANALYSIS

HINT:

In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

The following 5 items are important points in the problem analysis:

What	Vehicle model, system name
When	Date, time, occurrence frequency
Where	Road conditions
Under what conditions?	Driving conditions, weather conditions
How did it happen?	Problem symptoms

3.	INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

4.	PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table (See page ).

Result	Proceed to
Fault is not listed in Problem Symptoms Table.	A
Fault is listed in Problem Symptoms Table.	B

GO TO STEP 6

5.	OVERALL ANALYSIS AND TROUBLESHOOTING

(a) Terminals of ECU (See page ).

6.	REPAIR OR REPLACE

7.	CONFIRMATION TEST

END

System Diagram

SYSTEM DIAGRAM Communication Table Transmitting ECU Receiving ECU Signal Communication Method Air Conditioning Control Assembly ...

System Description

SYSTEM DESCRIPTION 1. GENERAL The windshield deicer system's thin heater wires are attached to the inside of the front window and deice the window surface quickly. The indicator light illumina ...

Other materials about Toyota Venza:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure listed is for the LH side. PROCEDURE 1. REMOVE FRONT WHEEL 2. DRAIN BRAKE FLUID NOTICE: If brake fluid leaks onto any pa ...

Theft Deterrent System Communication Line High Fixation (B279A)
DESCRIPTION If the communication line (EFIO - IMI) to the certification ECU (smart key ECU assembly) is stuck high output (e.g. shorted to +B), the ECM stores this DTC. DTC No. DTC Detection Condition Trouble Area ...

Tire information
Typical tire symbols ►Standard tire ►Compact spare tire 1. Tire size 2. DOT and Tire Identification Number (TIN) 3. Location of treadwear indicators 4. Tire ply composition and materials Plies are layers of rubber-coated parallel cords ...