Toyota Venza manuals

Toyota Venza: Precaution

PRECAUTION

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name

See Procedure

Back Door Closer System


Power Back Door System

1. PRECAUTION OF WASHER NOZZLE ADJUSTMENT

(a) Do not clean or adjust the washer nozzle with a safety pin, etc. because:

(1) the washer nozzle tip is made of resin and could be damaged.

(2) adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.

(b) If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.

Wiper And Washer System
...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the wiper and washer system. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT BRAKE BOOSTER ASSEMBLY (a) Airtightness check (1) Start the engine and stop it after 1 or 2 minutes. Slowly depress the brake pedal several times. HINT: If the pedal can be depressed to the ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. DTC CHECK (USING SST CHECK WIRE) (a) Turn the ignition switch off. (b) Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3. SST: 09843-18040 (c) Turn the ignition switch to ON. (d) Read and record any DTCs from the tire pre ...

Microphone Circuit between Microphone and Navigation Receiver Assembly
DESCRIPTION The navigation receiver assembly and inner rear view mirror assembly (amplifier microphone assembly) are connected to each other using the microphone connection detection signal lines. Using this circuit, the navigation receiver ...

© 2016-2026 Copyright www.tovenza.com

0.1611