Toyota Venza: Tire And Wheel System

Tire / Wheel

...

How To Proceed With Troubleshooting

PROCEDURE 1. CHECK TIRE AND WHEEL SYSTEM DIAGNOSIS OF IRREGULAR TIRE WEAR GO TO STEP 11 DIAGNOSIS OF TIRE VIBRATIO ...

Other materials about Toyota Venza:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK POWER BACK DOOR ECU (POWER BACK DOOR MOTOR UNIT) (a) Disconnect the L20 ECU connector. (b) Measure the voltage and resistance according to the value(s) in the table below. Tester Connection Wiring Color ...

Test Mode Procedure
TEST MODE PROCEDURE 1. ENTER TEST MODE (SIGNAL CHECK MODE) (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON. (d) Check that the tire pressure warning light comes on for 3 seconds and then goes ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR DOOR SCUFF PLATE RH HINT: Use the same procedure for the RH side and the LH side (See page ). 2. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH HINT: Use the same procedure for the RH side and the LH side (See page ). ...