Toyota Venza: Sound Quality is Bad Only when CD is Played (Volume is Too Low)

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Sound Quality is Bad Only when CD is Played (Volume is Too Low)

PROCEDURE

1.	REPLACE CD AND RECHECK

(a) Replace the CD with a known good one and check that the malfunction disappears.

OK:

Malfunction disappears.

END

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

No Sound can be Heard from Speakers

PROCEDURE 1. CHECK AUDIO SETTINGS (a) In sound setting mode, set volume, fader and balance to the initial values and check that the sound is normal. OK: Audio sy ...

CD cannot be Ejected

PROCEDURE 1. CHECK OPERATION (a) Press the disc eject switch of the radio and display receiver assembly for 5 seconds or more and check that the CD is ejected. OK: ...

Other materials about Toyota Venza:

Transmission Range Sensor Circuit Malfunction (PRNDL Input) (P0705)
DESCRIPTION The park/neutral position switch assembly detects the shift lever position and sends signals to the ECM. DTC No. DTC Detection Condition Trouble Area P0705 One of the following condit ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR AXLE CARRIER SUB-ASSEMBLY (a) Temporarily install the rea ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DOOR LOCK ASSEMBLY NOTICE: When reusing the removed rear door lock assembly, replace the door lock wiring harness seal on the connector with a new one. Do not allow grease or dust to adhere to the door ...