PROCEDURE
|
1. |
CHECK OPERATION |
(a) Press the disc eject switch of the radio and display receiver assembly for 5 seconds or more and check that the CD is ejected.
OK:
CD is ejected.
| NG | |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
|
|
2. |
REPLACE CD AND RECHECK |
(a) Replace the CD with a known good one and check that the malfunction disappears.
OK:
CD is ejected.
| OK | |
END (CD WAS FAULTY) |
| NG | |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
Sound Quality is Bad Only when CD is Played (Volume is Too Low)
CD cannot be Inserted / Played or CD is Ejected Right After InsertionBrake Line
Precaution
PRECAUTION
1. TROUBLESHOOTING PRECAUTION
NOTICE:
Since the brake lines are critical safety related parts, be sure to
disassemble and inspect the components if a brake fluid leak is found. If
any abnormality is found, replace th ...
Driving the vehicle
The following procedures should be observed to ensure safe driving.
- Starting the engine
- Driving
With the brake pedal depressed,
shift the shift lever to “D”.
Release the parking brake.
Gradually release the brake pedal
and gentl ...
Lost Communication with Rear Airbag Sensor LH (B1637/82,B1638/82,B1647/82,B1697/82,B1698/82)
DESCRIPTION
The side collision sensor LH circuit (to determine deployment of the front seat
side airbag assembly LH and curtain shield airbag assembly LH) is composed of the
center airbag sensor assembly, rear airbag sensor LH and side airbag sensor LH.
...