Toyota Venza: Sound of Portable Player cannot be Heard from Speakers or Sound is Low

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / Sound of Portable Player cannot be Heard from Speakers or Sound is Low

PROCEDURE

1.	CHECK PORTABLE PLAYER SETTINGS

(a) Check the portable player settings.

(1) Check that the volume is not set to "0".

(2) Check that mute is off.

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.

END

2.	CHECK AUDIO SETTINGS

(a) Check the audio settings.

(1) Check that the volume is not set to "0".

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.

END

3.	CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check that the sound of the portable player can be heard from the speakers of another "Bluetooth" audio compatible vehicle of the same model.

OK:

Sound of the portable player can be heard from the speakers.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

MALFUNCTION IN PORTABLE PLAYER

Cellular Phone Registration Failure

PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updatin ...

Does not Play even after Bluetooth Audio Mode is Selected

CAUTION / NOTICE / HINT HINT: Even if the portable player can play audio content, it may not be able to play via the in-vehicle device. This does not necessarily indicate a malfunction of the in ...

Other materials about Toyota Venza:

Front Sensor Communication Malfunction (C1AEC)
DESCRIPTION This DTC is stored when there is an open or short circuit in the communication line between the front sensors and the ECU, or when there is a malfunction in a front sensor. DTC No. DTC Detection Condition Trou ...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the wiper and washer system. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) (a) Disconnect the main body ECU (driver side junction block assembly) connectors. (b) Measure the resistance and voltage according to the value(s) in the table below. ...