Toyota Venza: Poor Sound Quality in All Modes (Low Volume)

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Poor Sound Quality in All Modes (Low Volume)

PROCEDURE

1.	CHECK AUDIO SETTINGS

(a) Set treble, middle and bass to the initial values and check that the sound is normal.

OK:

The sound returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

END

2.	COMPARE WITH ANOTHER VEHICLE OF SAME MODEL

(a) Compare with another vehicle of the same model which is not malfunctioning to see if there is any difference in the sound quality.

OK:

No difference is found.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Screen Flicker or Color Distortion

PROCEDURE 1. CHECK DISPLAY SETTING (a) Reset display settings (contrast, brightness) and check that the screen appears normal. OK: The display returns to normal. ...

Voice Guidance does not Function

PROCEDURE 1. CHECK VOICE GUIDANCE SETTING (a) Check that the voice guidance setting is not off. OK: Voice guidance setting is not off. NG CHANG ...

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater Syste ...

Dtc Check / Clear
DTC CHECK / CLEAR NOTICE: When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame ...

Installation
INSTALLATION PROCEDURE 1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY (a) Install the spiral with sensor cable sub-assembly (See page ). NOTICE: Do not replace the spiral cable with the battery connected and the engine switch on (IG). ...