Toyota Venza: Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

Toyota Venza Service Manual / Audio / Video / Audio And Visual System / Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

CAUTION / NOTICE / HINT

NOTICE:

Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast.

PROCEDURE

1.	CHECK SATELLITE RADIO

(a) Check radio condition.

Result	Proceed to
Broadcast cannot be selected.	A
Broadcast can be selected, but selection cannot be memorized.	B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

2.	CHECK SATELLITE RADIO

(a) Check the number of preset channels.

OK:

36 channels have already been preset.

END (ONLY 36 CHANNELS CAN BE PRESET)

3.	CHECK BATTERY

(a) Check if the battery was replaced.

OK:

Battery was not replaced.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

4.	ADD PRESET CHANNEL INTO MEMORY AGAIN

(a) Check if the preset channels that have been cleared can be added into memory again.

OK:

Preset channels can be added into memory.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Noise Occurs

PROCEDURE 1. NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise source ca ...

No Sound can be Heard from Speakers

PROCEDURE 1. CHECK AUDIO SETTINGS (a) In sound setting mode, set volume, fader and balance to the initial values and check that the sound is normal. OK: Audio sy ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION (a) Apply the parking brake. (b) Turn the ignition switch to ON. (c) Depress the brake pedal and check that the engine starts when the shift lever is in N or P, b ...

Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 MANIFOLD CONVERTER INSULATOR (a) Install the No. 1 manifold converter insulator to the exhaust manifold converter sub-assembly with the 4 bolts. Torque: 12 N·m {122 kgf·cm, 9 ft·lbf} ...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: *: Use the Techstream PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2. CUSTOMER PROBLEM ANALYSIS ...