Toyota Venza: Removal

Toyota Venza Service Manual / Window / Glass / Power Window Regulator Motor(for Rear Door) / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See page ).

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

6. REMOVE REAR DOOR SERVICE HOLE COVER

7. REMOVE REAR DOOR GLASS RUN

8. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

10. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY

11. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a T25 "TORX" driver, remove the 3 screws and the rear power window regulator motor assembly.

Inspection

INSPECTION PROCEDURE 1. INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (a) Apply positive (+) battery voltage to connector terminal 2 (B). NOTICE: Do not apply positive (+) ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR POWER WIN ...

Other materials about Toyota Venza:

Yaw Rate Sensor Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Yaw Rate Sensor Communication Stop Mode "Yaw Rate/Decelerate Sensor" is not displayed on "CAN Bus Check" screen o ...

XM Tuner Malfunction (B15BA)
DESCRIPTION This DTC is stored when a malfunction occurs in the stereo component tuner assembly. DTC No. DTC Detection Condition Trouble Area B15BA When either of the following conditions is met: ...

Steering wheel
The steering wheel can be adjusted to a comfortable position. Hold the steering wheel and press the lever down. Adjust to the ideal position by moving the steering wheel horizontally and vertically. After adjustment, pull the lever up to secure the stee ...