INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
NOTICE:
The regulator arm must be below the intermediate position when installing the rear power window regulator motor assembly.
|
(a) Using a T25 "TORX" driver, install the rear power window regulator motor assembly with the 3 screws. Torque: 5.4 N·m {55 kgf·cm, 48 in·lbf} HINT: A new rear window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted. |
|
2. INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY
3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY
4. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
5. INSTALL REAR DOOR GLASS RUN
6. INSTALL REAR DOOR SERVICE HOLE COVER
7. INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
9. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
10. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page
).
12. INITIALIZE POWER WINDOW CONTROL SYSTEM
(See page
)
RemovalData List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful bec ...
All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch
DESCRIPTION
The main body ECU (driver side junction block assembly) receives switch signals
from the door control switch and activates the door lock motor on each door according
to these signals.
WIRING DIAGRAM
PROCEDURE
1.
REA ...
XM Tuner Antenna Disconnected (B15FE,B15FF)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the roof antenna assembly
which is connected to the stereo component tuner assembly.
DTC No.
DTC Detection Condition
Trouble Area
B15FE
...