Toyota Venza manuals

Toyota Venza: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Tire Pressure Warning System

Symptom

Suspected Area

See page

Tire pressure warning light does not illuminate, despite tire pressure decreasing

Check Data List (ID tire inflation pressure)


ID code check (Registration)


Tire pressure warning light remains illuminated (Goes off during initial check)

ECU power source circuit


Tire pressure warning light circuit


Tire pressure warning light remains illuminated (Comes on during initial check)

Check Data List (ID tire inflation pressure)


Tire pressure warning light circuit


ID code check (Registration)


DTC check cannot be done

ECU power source circuit


TC and CG terminal circuit


Registration
REGISTRATION PROCEDURE 1. DESCRIPTION OF CODE REGISTRATION It is necessary to register the transmitter IDs in the tire pressure warning ECU when replacing a tire pressure warning valve and transm ...

Test Mode Procedure
TEST MODE PROCEDURE 1. ENTER TEST MODE (SIGNAL CHECK MODE) (a) Turn the ignition switch off. (b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON. (d) Check that the tire pr ...

Other materials about Toyota Venza:

Diagnosis System
DIAGNOSIS SYSTEM 1. CHECK DLC3 (a) Check the DLC3 (See page ). 2. FUNCTION OF SRS WARNING LIGHT (a) Primary check (1) Turn the ignition switch off. Wait for at least 2 seconds, then turn the ignition switch to ON. The SRS warning light comes on for app ...

Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use an overhaul stand as necessary. PROCEDURE 1. REMOVE REAR DIFFERENTIAL FILLER PLUG (a) Remove the rear differential filler plug and gasket. 2. INSPECT ...

Registration
REGISTRATION PROCEDURE 1. DESCRIPTION OF CODE REGISTRATION HINT: The key has 2 codes: the key code (immobiliser code) and the wireless code. Both of these codes need to be registered. For the wireless code registration procedures, refer to Wireless Doo ...

© 2016-2026 Copyright www.tovenza.com

0.1305