Toyota Venza manuals

Toyota Venza: Precaution

PRECAUTION

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name

See Procedure

Back Door Closer System


Power Back Door System

Windshield Deicer System
...

Parts Location
PARTS LOCATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (See page ). 2. INSPECT CENTER AIRBAG SENSOR ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT D ...

Short in Curtain Shield Squib LH Circuit (B1835/58-B1838/58)
DESCRIPTION The curtain shield squib LH circuit consists of the center airbag sensor assembly and curtain shield airbag assembly LH. The center airbag sensor assembly uses this circuit to deploy the airbag when deployment conditions are met. These DTCs ...

Replacement
REPLACEMENT PROCEDURE 1. REPLACE GENERATOR DRIVE END FRAME BEARING (a) Remove the 4 screws and bearing retainer from the drive end frame. (b) Using SST and a hammer, tap out the drive end ...

© 2016-2026 Copyright www.tovenza.com

0.1616