Toyota Venza manuals

Toyota Venza: Precaution

PRECAUTION

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected.

System Name

See Procedure

Back Door Closer System


Power Back Door System

Parts Location
PARTS LOCATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

System Description
SYSTEM DESCRIPTION 1. POWER BACK DOOR SYSTEM DESCRIPTION (a) The power back door system controls the power back door by automatically opening and closing the power back door with a motor. (1) The ...

Other materials about Toyota Venza:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/o Sliding Roof) 2. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Sliding Roof) 3. REMOVE VANITY LIGHT ASSEMBLY (a) Remove the vanity light assembly (See page ). HINT: Use the same p ...

Differential System
Precaution PRECAUTION Before disassembly, clean the outside of the differential assembly and remove any sand or mud to prevent it from entering the inside of the assembly during disassembly and installation. When removing an installed pa ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK BATTERY CONDITION NOTICE: If the battery is weak or if the engine is difficult to start, perform the following procedure. (a) Check the battery for damage and deformation. If severe damage, deformation or leaka ...

© 2016-2026 Copyright www.tovenza.com

0.1408