Toyota Venza: Precaution

HINT:

• Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
• When both standard and maximum or minimum values are listed for an inspection, use the standard value as a reference only and base any judgments on the maximum and minimum values.

Engine Unit

...

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Other materials about Toyota Venza:

Front Stabilizer Bar(when Not Using The Engine Support Bridge For Awd)
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT FRONT STABILIZER LINK ASSEMBLY (a) Inspect the turning torque of the ball joint. (1) Secure the front stabilizer link assembly in a vise using aluminum ...

Electrical Key Oscillator(for Rear Floor)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 2. REMOVE DECK BOARD ASSEMBLY 3. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY 4. REMOVE DECK SIDE TRIM BOX LH 5. REMOVE NO. 2 D ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FRONT LOWER SUSPENSION ARM (a) Install the front lower arm bushing stopper t ...