Toyota Venza: Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

Toyota Venza Service Manual / Navigation / Multi Info Display / Navigation System / Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

CAUTION / NOTICE / HINT

NOTICE:

Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast.

PROCEDURE

1.	CHECK SATELLITE RADIO

(a) Check radio condition.

Result	Proceed to
Broadcast cannot be selected.	A
Broadcast can be selected, but selection cannot be memorized.	B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

2.	CHECK SATELLITE RADIO

(a) Check the number of preset channels.

OK:

36 channels have already been preset.

END (ONLY 36 CHANNELS CAN BE PRESET)

3.	CHECK BATTERY

(a) Check if the battery was replaced.

OK:

Battery was not replaced.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

4.	ADD PRESET CHANNEL INTO MEMORY AGAIN

(a) Check if the preset channels that have been cleared can be added into memory again.

OK:

Preset channels can be added into memory.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Satellite Radio Broadcast cannot be Received

CAUTION / NOTICE / HINT NOTICE: Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be p ...

Noise Occurs

PROCEDURE 1. CHECK NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise sou ...

Other materials about Toyota Venza:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ...

Engine
General Maintenance GENERAL MAINTENANCE CAUTION / NOTICE / HINT HINT: Perform these procedures after the engine has cooled down. PROCEDURE 1. INSPECT DRIVE BELT Engine Type See Procedure 2GR-FE See pag ...

Removal
REMOVAL PROCEDURE 1. REMOVE REAR DOOR SCUFF PLATE LH 2. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH 3. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 4. REMOVE DECK BOARD ASSEMBLY 5. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY 6. REMOVE ...