Toyota Venza: Precaution

HINT:

• Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
• When both standard and maximum or minimum values are listed for an inspection, use the standard value as a reference only and base any judgments on the maximum and minimum values.

Cylinder Block

Components

Other materials about Toyota Venza:

Removal
REMOVAL PROCEDURE 1. REMOVE REAR DOOR SCUFF PLATE 2. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 3. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 4. REMOVE DECK BOARD ASSEMBLY 5. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY 6. REMOVE DECK S ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COOLER CONDENSER ASSEMBLY (a) If the cooler condenser assembly fins are dirty, clean them with water and dry with compressed air. NOTICE: Do not damage the cooler condenser assembly fins. (b) If any cooler con ...

Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (a) Align the splines of the shaft and install the drive shaft assembly LH using a brass bar and a hammer. NOTICE: Set the shaft snap ring with the opening fac ...