CAUTION / NOTICE / HINT
HINT:
Some versions of "Bluetooth" compatible audio players may not function properly,
or the functions may be limited using the navigation receiver assembly, even if
the portable audio player itself can play files (See page
).
PROCEDURE
|
1. |
CHECK THAT PORTABLE PLAYER IS "Bluetooth" AUDIO COMPATIBLE |
(a) Check if the portable player is "Bluetooth" audio compatible.
|
Result |
Proceed to |
|---|---|
|
The portable player is "Bluetooth" audio compatible. |
A |
|
The portable player is not "Bluetooth" audio compatible. |
B |
| B | |
USE A "Bluetooth" AUDIO COMPATIBLE PORTABLE PLAYER |
|
|
2. |
CHECK CONNECTION PROCEDURE OF CONNECTED DEVICE |
(a) Referring to Owner's Manual, correctly register the portable player.
(b) Check that the portable player has been registered as a connected device.
The portable player cannot be registered under any of the following conditions:
OK:
The portable player has been registered as a connected device.
| OK | |
END |
|
|
3. |
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check if the portable player can be registered normally to another "Bluetooth" audio compatible vehicle of the same model.
OK:
The portable player can be registered.
| NG | |
MALFUNCTION IN PORTABLE PLAYER |
|
|
4. |
REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES |
(a) Remove additional devices which use radio waves.
(b) Place the portable player close to the navigation receiver assembly.
(c) Check that the portable player can be registered as a connected device.
OK:
The portable player can be registered.
| OK | |
END |
| NG | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Registered Device cannot be Deleted
USB Audio System Recognition/Play ErrorClock Display Circuit
DESCRIPTION
The accessory meter assembly uses this circuit to communicate with the combination
meter assembly via the direct line. The accessory meter assembly uses this circuit
to receive the drive monitor switch signals from the combination meter assemb ...
High Mounted Stop Light Assembly
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE CENTER STOP LIGHT ASSEMBLY
(a) Using a short screwdriver, remove the 2 screws.
(b) Disconnect the connector and remov ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
If installing a new rear differential carrier assembly, remove the 2 differential
side seal caps before installing the rear drive shaft assembly.
PROCEDURE
1. INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER
HINT:
...