Toyota Venza: Installation

Toyota Venza Service Manual / Audio / Video / Luggage Speaker / Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR NO. 3 SPEAKER ASSEMBLY

(a) Install the rear No. 3 speaker assembly with the 2 bolts.

(b) Engage the clamp.

2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH

3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

4. CONNECT REAR SEAT OUTER BELT ASSEMBLY LH

5. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (for LH Side)

6. INSTALL RECLINING REMOTE CONTROL BEZEL LH

7. INSTALL REAR SEAT ASSEMBLY LH

8. CONNECT REAR SEAT NO. 2 RECLINING CONTROL CABLE SUB-ASSEMBLY

9. INSTALL REAR SEAT OUTER TRACK BRACKET COVER

10. INSTALL REAR SEAT INNER TRACK BRACKET COVER

11. INSTALL REAR SEAT HEADREST ASSEMBLY

12. INSTALL REAR FLOOR FINISH PLATE

13. INSTALL REAR SEAT SUB FLOOR PANEL ASSEMBLY

14. INSTALL NO. 1 DECK BOARD

15. INSTALL DECK SIDE TRIM BOX RH

16. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY

17. INSTALL DECK SIDE TRIM BOX LH

18. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY

19. INSTALL DECK BOARD ASSEMBLY

20. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

21. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

22. INSTALL REAR DOOR SCUFF PLATE LH

Inspection

INSPECTION PROCEDURE 1. INSPECT REAR NO. 3 SPEAKER ASSEMBLY (for 13 Speakers) (a) With the speaker installed, check that there is no looseness or other abnormalities. (b) Check that there is no fo ...

Microphone

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER 2. REMOVE TELEPHONE MICROPHONE ASSEMBLY (INNER REAR VIEW MIRROR ASSEMBLY ...

Other materials about Toyota Venza:

Power Mirrors do not Return to Memorized Position
SYSTEM DESCRIPTION If either the M1 or M2 seat memory switch is pressed, the outer mirror control ECU assembly (driver door) detects the seat memory switch status and sends the switch signal to the main body ECU (driver side junction block assembly) via C ...

Stop Light Control Relay Malfunction (C1380/64)
DESCRIPTION Upon receiving the hill-start assist control operating signal from the skid control ECU, the relay contact turns on and the stop light comes on. DTC Code DTC Detection Condition Trouble Area C13 ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the LH side and RH side. The following procedure listed is for the LH side. PROCEDURE 1. REMOVE REAR WHEEL 2. DRAIN BRAKE FLUID NOTICE: If brake fluid leaks onto any pai ...