Toyota Venza: Installation

Toyota Venza Service Manual / Interior Panels / Trim / Front Console Box / Installation

INSTALLATION

PROCEDURE

1. INSTALL CONSOLE BOX ASSEMBLY

(a) Connect the connectors.

(b) Engage the 2 claws.

(d) Install the console box assembly with the 2 bolts.

2. INSTALL NO. 2 CONSOLE BOX CARPET

(a) Install the No. 2 console box carpet.

3. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)

4. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)

Removal

REMOVAL PROCEDURE 1. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System) 2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System) 3. REMOVE NO. 2 CONSOLE BOX CARPET ...

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL REAR CONSOLE ARMREST ASSEMBLY (a) Temporarily install the rear console armrest assembly. (b) Push in the box door hinge shafts by hand as far as possible ...

Other materials about Toyota Venza:

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by the blinking pattern of the tire pressure warning light. WIRING DIAGRAM HINT: When various warning lights blink continuously, a ground ...

Rear Height Control Sensor (B241A)
DESCRIPTION The headlight leveling ECU assembly receives signals indicating the height of the vehicle from the rear height control sensor sub-assembly RH. DTC No. DTC Detecting Condition Trouble Area B241A ...

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. (b) Install the No. 2 ste ...