Toyota Venza manuals

Toyota Venza: Freeze Frame Data

FREEZE FRAME DATA

1. CHECK FREEZE FRAME DATA

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

(e) Select a DTC to display its freeze frame data.

2. LIST OF FREEZE FRAME DATA

(a) Refer to Data List / Active Test (See page ).


Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when dec ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Navigation System DTC Code Detection Item See page B1532 LVDS Signal Malfunction (from Extension Module) ...

Other materials about Toyota Venza:

Engine Oil Cooler
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE EXHAUST MANIFOLD ASSEMBLY HINT: See page 2. DRAIN ENGINE OIL 3. DRAIN ENGINE COOLANT 4. REMOVE OIL COOLER ASSEMBLY (a) Remove the nut, union bolt, seal ...

Installation
INSTALLATION PROCEDURE 1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY NOTICE: Do not replace the spiral cable with the battery connected and the ignition switch on (IG). Do not rotate the spiral cable with the battery connected and the ig ...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: The TCM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication system. *: U ...

© 2016-2026 Copyright www.tovenza.com

0.1416