Toyota Venza manuals

Toyota Venza: Entry Interior Alarm does not Sound

DESCRIPTION

The smart key system uses the combination meter buzzer to perform various vehicle interior warnings. When the conditions for each warning are met, the certification ECU (smart key ECU assembly) sends a buzzer signal to the combination meter assembly, and the combination meter buzzer sounds.

CAUTION / NOTICE / HINT

NOTICE:

The smart key system (for entry function) uses a multiplex communication system (LIN communication system) and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (See page ). Troubleshoot the smart key system (for entry
function) after confirming that the communication system is functioning properly.

PROCEDURE

1.

CHECK COMBINATION METER ASSEMBLY (OPERATION)

(a) When the engine switch is on (IG) and the shift lever is in R, check that the combination meter buzzer sounds.

OK:

Combination meter buzzer sounds.


OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


NG

GO TO METER / GAUGE SYSTEM (Proceed to Problem Symptoms Table)

Room Oscillator does not Recognize Key
DESCRIPTION If the room oscillator does not recognize a key, one of the following may be the cause: 1) communication between the indoor electrical key oscillator (for front floor) and key cannot ...

Back Door Entry Unlock Function does not Operate
DESCRIPTION If the entry back door open function does not operate but the back door entry lock function operates, the communication between the vehicle and key is normal. As a faulty part, the ba ...

Other materials about Toyota Venza:

Adjustment
ADJUSTMENT PROCEDURE 1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Remove the transmission control shaft lever. HINT: See the steps from "Remove Cool Air Intake Duct Seal" through "Remove Park/Neutral Position Switch Assembly" ...

Terminals Of Ecu
TERMINALS OF ECU 1. CENTER AIRBAG SENSOR ASSEMBLY Terminal No. Terminal Symbol Destination L31-1 SFL+ Front seat side airbag assembly LH (Side squib LH) L31-2 ...

Manual Shifting Test
MANUAL SHIFTING TEST 1. PERFORM MANUAL SHIFTING TEST HINT: Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transaxle. If any abnormalities are found in the following ...

© 2016-2026 Copyright www.tovenza.com

0.1464