Toyota Venza: Engine Circuit Malfunction (C1280/82)

Toyota Venza Service Manual / Mf1a Transfer / 4wd / Awd / Active Torque Control 4wd System / Engine Circuit Malfunction (C1280/82)

DESCRIPTION

If a malfunction in the ECM circuit occurs, the AWD control ECU will output this DTC.

DTC No.	DTC Detection Condition	Trouble Area
C1280/82	When the following continues for 5 seconds or more: - Communication with engine control ECM is operating normally, but SFI system is malfunctioning.	SFI system AWD control ECU

CAUTION / NOTICE / HINT

HINT:

Check the condition of each related circuit connector before troubleshooting (See page ).

PROCEDURE

1.	CHECK FOR DTC (SFI SYSTEM)

(a) Check if the SFI system DTC is output (See page ).

Result	Proceed to
SFI system DTC is not output	A
SFI system DTC is output	B

REPLACE AWD CONTROL ECU

GO TO SFI SYSTEM

Linear Solenoid Circuit (C1298/98)

DESCRIPTION The AWD control ECU receives signals from each sensor to control clutch pressure to distribute torque according to the driving conditions. DTC No. DTC Detection C ...

AWD Warning Light does not Come ON

DESCRIPTION Refer to "AWD Warning Light Remains ON" (See page ). WIRING DIAGRAM Refer to "AWD Warning Light Remains ON" (See page ). CAUTION / NOTICE / HINT Check the cond ...

Other materials about Toyota Venza:

Driver Side Power Mirror cannot be Adjusted with Power Mirror Switch
SYSTEM DESCRIPTION When the mirror adjust switch is operated, the main body ECU (driver side junction block assembly) detects the switch operation and sends the mirror adjust switch signal to the outer mirror control ECU assembly (driver door) via CAN com ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column ...

Noise Occurs
PROCEDURE 1. NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise source can be determined. NG GO TO STEP 3 ...