Toyota Venza manuals

Toyota Venza: Engine

Drive Belt
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT V-RIBBED BELT (a) Check the belt for wear, cracks or other signs of damage. ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT See page 2. INSPECT ENGINE OIL See page 3. INSPECT BATTERY See page 4. INSPECT AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY (a) Remo ...

Other materials about Toyota Venza:

Cold Start Idle Air Control System Performance (P050A)
MONITOR DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC is stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the idl ...

Installation
INSTALLATION PROCEDURE 1. INSTALL REAR DRIVE SHAFT ASSEMBLY (a) Align the shaft splines and install the rear drive shaft assembly using a screwdriver and hammer. NOTICE: Set the snap ring with the opening facing downward. ...

Transfer Case Front Oil Seal(for Rh Side)
Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. DRAIN TRANSFER OIL (a) Remove the transfer drain plug and gasket to drain the transfer oil. (b) Install a new gasket and the transfer drain plug. Torque: 49 N·m {500 kgf ...

© 2016-2026 Copyright www.tovenza.com

0.1704