DISASSEMBLY
PROCEDURE
1. REMOVE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY
(a) Mount the brake master cylinder sub-assembly in a vise.
NOTICE:
Place aluminum plates on the vise to prevent damage to the brake master cylinder sub-assembly.
|
(b) Using a pin punch and a hammer, tap out the straight pin and remove the brake master cylinder reservoir assembly. |
|
(c) Remove the 2 master cylinder reservoir grommets from the brake master cylinder reservoir assembly.
Components
RemovalOne or more Power Seat Motors do not Operate
DESCRIPTION
Signals are input into the position control ECU and switch assembly. The built-in
ECU manages the signals received from the position control ECU and switch assembly,
and operates each motor. If the position control ECU and switch assembly rece ...
Alarm
The system sounds the alarm and flashes lights when forcible entry is detected.
- Triggering of the alarm
The alarm is triggered in the following situations when the alarm is set.
• A locked door is unlocked or opened in any way other than by using ...
Regulations on the use of tire chains
• Regulations regarding the use of tire chains vary according to location and
type of road. Always check local regulations before installing chains.
• Retighten the chains after driving 1/4 - 1/2 mile (0.5 - 1.0 km).
- Tire chains
Observe the fo ...