Toyota Venza manuals

Toyota Venza: Diagnosis System

DIAGNOSIS SYSTEM

1. DESCRIPTION

(a) Lighting system data can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.

2. CHECK DLC3

(a) Check the DLC3 (See page ).


3. INSPECT BATTERY VOLTAGE

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY) (a) Disconnect the 2A and 2F main body ECU (driver side junction block assembly) connectors. (b) Measure the voltag ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuator and other items to be read without removing any pa ...

Other materials about Toyota Venza:

Voice is not Recognized
PROCEDURE 1. CHECK CONDITION (a) Check if the system voice recognition level is low when recognizing a particular voice. Result Proceed to System voice recognition level is low only fo ...

Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: When disconnecting the steering intermediate shaft assembly and pinion shaft of the steering gear assembly, be sure to place matchmarks before servicing. PROCEDURE 1. INSTALL TIE ROD ASSEMBLY LH ( ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 3. REMOVE COOL AIR ...

© 2016-2026 Copyright www.tovenza.com

0.1424