Toyota Venza: Cruise Control Input Circuit (P0575)

Toyota Venza Service Manual / Cruise Control / Cruise Control System / Cruise Control Input Circuit (P0575)

DESCRIPTION

This DTC indicates the internal abnormalities of the ECM.

DTC	DTC Detection Condition	Trouble Area
P0575	When both of the following conditions are met: STP signals input to the ECM supervisory CPU and control ECU are different for 0.15 seconds or more 0.4 seconds have passed after cruise cancel input signal (STP input) is input to the ECM	ECM

HINT:

The ECM receives signals from each sensor to control all functions of the cruise control system. When a trouble code is detected, the fail-safe function activates and remains on until the ignition switch is turned off.

PROCEDURE

1.	READ OUTPUT DTC (P0575)

(a) Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

(b) Connect the cable to the negative (-) battery terminal.

(d) Turn the ignition switch to ON.

(e) Turn the Techstream on.

(f) Enter the following menus: Powertrain / Cruise Control / DTC.

(g) Read the DTCs.

Result	Proceed to
DTC P0575 is not output	A
DTC P0575 is output (for 1AR-FE)	B
DTC P0575 is output (for 2GR-FE)	C

USE SIMULATION METHOD TO CHECK

REPLACE ECM

Brake Switch "A" Circuit (P0571)

DESCRIPTION When the brake pedal is depressed, the stop light switch assembly sends a signal to the ECM. When the ECM receives this signal, it cancels the cruise control. The fail-safe function o ...

Cruise Control Switch Circuit

DESCRIPTION The cruise control main switch operates 7 functions: SET, -, TAP-DOWN, RES, +, TAP-UP, and CANCEL. The SET, TAP-DOWN, and - functions, and the RES, TAP-UP, and + functions are operate ...

Other materials about Toyota Venza:

Rear Left Center Sensor Malfunction (C1AE7)
DESCRIPTION The No. 1 ultrasonic sensor (rear left center sensor) is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (rear left center sensor). If the No. 1 ultrasonic sensor (rear left ce ...

Precaution
PRECAUTION NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected. System Name See Procedure Back Door Closer System ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...