Toyota Venza: Components

Front Seat Cushion Heater

...

Removal

REMOVAL PROCEDURE 1. REMOVE FRONT SEAT HEADREST ASSEMBLY 2. REMOVE FRONT SEAT REAR OUTER TRACK COVER 3. REMOVE FRONT SEAT REAR INNER TRACK COVER 4. REMOVE FRONT SEAT ASSEMBLY 5. REMOVE ...

Other materials about Toyota Venza:

Front Occupant Classification Sensor RH Collision Detection (B1786)
DESCRIPTION DTC B1786 is output when the occupant classification ECU receives a collision detection signal sent by the front occupant classification sensor RH if an accident occurs. DTC B1786 is also output when the front seat assembly RH is subjected to ...

VIN not Programmed or Mismatch - ECM / PCM (P0630)
MONITOR DESCRIPTION DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the Engine Control Module (ECM) or the input VIN is not accurate. Input the VIN with the Techstream. DTC No. DTC Detection Conditi ...

Installation
INSTALLATION PROCEDURE 1. INSTALL POWER SEAT SWITCH (a) Install the power seat switch with the 3 screws. (b) Connect the connector. 2. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY 3. INSTALL SLID ...