Toyota Venza: Components

Cylinder Head Gasket

...

Removal

REMOVAL PROCEDURE 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (a) Remove the engine and transaxle (See page ). 2. REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (a) Remove the exhaust manifold con ...

Other materials about Toyota Venza:

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL TRANSFER DRIVEN PINION REAR BEARING (a) Using SST and a press, press the transfer driven pinion rear bearing (outer race) to the case. SST: 09950-60010 09951-00620 SST: 09950-70010 09951-07150 NO ...

Control Module Performance (P0607)
MONITOR DESCRIPTION The ECM continuously monitors its internal processors (CPUs) and heated oxygen sensor transistors. This self-check ensures that the ECM is functioning properly. DTC No. DTC Detection Condition Trouble Ar ...

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY NOTICE: The regulator arm mus ...