Toyota Venza manuals

Toyota Venza: Voice Guidance does not Function

PROCEDURE

1.

CHECK VOICE GUIDANCE

(a) Check that the voice guidance settings are not off.

OK:

Voice guidance settings are not off.


NG

CHANGE THE VOICE GUIDANCE SETTINGS TO ON


OK

2.

CHECK AUDIO FUNCTION

(a) Check that sound can be heard from a front speaker.

OK:

Sound can be heard.


OK

REPLACE NAVIGATION RECEIVER ASSEMBLY


NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Route cannot be Calculated
PROCEDURE 1. SET DESTINATION (a) Set another destination and check if the system can calculate the route correctly. OK: Route can be correctly calculated. ...

Voice is not Recognized
PROCEDURE 1. CHECK CONDITION (a) Check if the system voice recognition level is low when recognizing a particular voice. Result Proceed to ...

Other materials about Toyota Venza:

Pressure Control Solenoid "C" Performance (Shift Solenoid Valve SL3) (P0796)
SYSTEM DESCRIPTION The TCM uses the vehicle speed signal and signals from the transmission speed sensors (NC, NT) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear). Then the TCM compares the actual gear with the shift schedule in the TCM memo ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the clearance sonar main switch on. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Intuitive P/A / DTC. (f) ...

Microphone Circuit between Microphone and Navigation Receiver Assembly
DESCRIPTION The navigation receiver assembly and inner rear view mirror assembly (amplifier microphone assembly) are connected to each other using the microphone connection detection signal lines. Using this circuit, the navigation receiver ...

© 2016-2026 Copyright www.tovenza.com

0.1303