Toyota Venza manuals

Toyota Venza: Route cannot be Calculated

PROCEDURE

1.

SET DESTINATION

(a) Set another destination and check if the system can calculate the route correctly.

OK:

Route can be correctly calculated.


OK

END


NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

GPS Mark is not Displayed
PROCEDURE 1. CHECK CABIN (a) Check the cabin for any object that might interrupt radio reception or additional devices which use radio waves on the instrument panel ...

Voice Guidance does not Function
PROCEDURE 1. CHECK VOICE GUIDANCE (a) Check that the voice guidance settings are not off. OK: Voice guidance settings are not off. NG CHANGE TH ...

Other materials about Toyota Venza:

Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136 (See page ). HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the ignition switch is t ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE PROPELLER SHAFT (a) Place matchmarks on both flanges. Text in Illustration *1 Matchmark (b) Remove the 4 nuts, ...

Installation
INSTALLATION PROCEDURE 1. INSTALL POWER OUTLET SOCKET COVER NO.1 (a) Engage the 2 claws to install the power point socket cover. 2. INSTALL POWER POINT SOCKET ASSEMBLY (a) Engage the 2 c ...

© 2016-2026 Copyright www.tovenza.com

0.1504