Toyota Venza: Unlock Warning Switch

Transmitter Battery(w/o Smart Key System)

Replacement REPLACEMENT PROCEDURE 1. REMOVE TRANSMITTER HOUSING COVER (a) Using a precision screwdriver with its tip wrapped in protective tape, pry open the transmitter housing c ...

Components

COMPONENTS ILLUSTRATION ...

Other materials about Toyota Venza:

Throttle / Pedal Position Sensor / Switch "D" Circuit (P2120,P2122,P2123,P2125,P2127,P2128,P2138)
DESCRIPTION HINT: This Electronic Throttle Control System (ETCS) does not use a throttle cable. These DTCs relate to the accelerator pedal sensor assembly. The accelerator pedal sensor assembly is mounted on the accelerator pedal brack ...

Initialization
INITIALIZATION 1. Inspection After Repair Perform learning value reset and idle learning after replacing or servicing parts related to engine operation. Details on procedures required are indicated by an asterisk and a number, and are explained in detail ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The procedure listed below is for the LH side. PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ...